Hello, We are currently using a Be6000 system and when we schedule a call forwarding on our phones (model 7945) to external numbers, it works perfectly when the original call comes from an internal position, but when it is an external call then this ...
Hi EveryoneI’ve got this new Cisco IP phone 8945 and wanted to install the latest firmware (cmterm-894x-sccp.9-2-3-5.cop.sgn), to be able to use the new phone on our corporate CUCM 7.1.5.I’ve restarted TFTP services on both Publisher and Subscriber a...
Hello all. I currently use a SIP account Polish operator, but also I'd like to configure the router for Skype bussiness but i have problem. Does anyone have a sample config or useful link ? Thank You.
Hello,I believe CUCM SIP OPTIONS trunk monitoring was added in CUCM 8.5 (it's beyond me why it wasn't implemented in much earlier CUCM releases).Does anyone know of any way to do this in CUCM 7.1(5) where CUCM SIP OPTIONS is not supported? If one SIP...
Hello Friends,I have a voicemail account which has 1 Primay extension, 1 Alternate extension my requirement here is i need to have 2 different password for both the extensions but still i should have a single voicemail box for both the extensions.Is ...
We are getting the below error "%C5510-1-NO_RING_DESCRIPTORS" and isdn channels goes up/down, the Voice gateway is working for the past 3 years without any issuse ?.Please light me the issuse is because of PVDM or we need to upgarde IOS, the current ...
Is it possible to get someone to round out my knowledge of this a bit? I am looking to switch from a TSP to an ITSP. This will reduce the phone traffic costs of our company potentially by thousands of dollars a month.I am moving from CUCM 6.1 to CUCM...
Hi,I would like to know that can we use 9971, 9951 and 8961 phones to make video calls on multisite CUCME and if possible can i have some sample configuration links.Thanks.
I need your help in setting up/configuring the ATA 187 on gateway 3925 router for fax services.Thanks,Ali
I have a cluster with 4 subsbribers. The cluster is divided on 2 UCS plataforms.We have installed now a new C210 M2 at a remote site and installed on it 2 clusters of IPCC.Aditionally, we tried to install 1 Call manager subscriber.All the insllation ...
Hello UC People I have a question .. how long should CUCM 8.6 installation take "time"Thnx in advance
As a general rule, should transcoding be done close to the source or destination?Is there any link/documentation that I can reference?ThanksJames
7931phone is not registration cme router 2811
Hi all, hope you are finewell, here is my problemI got a CME connected with PBX, the pbx sip license is only 10 sip trunks, the CME has about 80 registered phone.There is a VIP cisco number that i need to make it reachable from the nortel pbx any tim...
Hi All,I have CUCM 8.0.3 configured with Extension Mobility. The issue I'm facing with: when user tries to log in, user asked for 'change PIN'. I have set PINs via BAT for all the users and that need to be used. How can I disable it?Thanks!Tibor
Is there a method to configure RP (Route pattern ) to block any calls outside working hours ?I am using CUCM 8.6
