Hello, We are currently using a Be6000 system and when we schedule a call forwarding on our phones (model 7945) to external numbers, it works perfectly when the original call comes from an internal position, but when it is an external call then this ...
I live in a place with frequent power outages. I don't mind losing the phone for few minutes, but the problem is that after SPA2102 reboots, the phone line is not working.After much investigation, it seems that it's happening because SPA2102 boots be...
Are the 6941, 6941, 6961 phones supported in any version of SRST using SIP? The documents at these links lead one to believe they are not.http://www.cisco.com/en/US/partner/docs/voice_ip_comm/cusrst/requirements/guide/srs71spc.htmlhttp://www.cisco.co...
Have a new 7962G. Looking for the detailed instructions to convert it to SIP to use on a 3rd Party Sip server.Can't seem to find a set of instructions....
Hi,My customer has requested to have the first two buttons of a 7971 as line buttons then have some speeddials, then have more line buttons. I can't seem to get the speeddials configured in amongst the line buttons - they appear after the line button...
Hi all, Somebody knows if are there a prevision to support locale in 9951 and CME? I have downloading the lastest locale file (CME_8.8_Locale) but the 9951 is still not present.The phone try to download the file Spanish_Spain/lk-sip.jarRegards.
hey guys, I have a client looking for the MSDS for the CP-BATT-7925G-STD=. I can't find it...can any of you help me locate it? Thanks!
Hi,I have installed a new phone in 6911/6941 a CME with IOS C2900-universalk9-mz.SPA.151-4.M.bin. The devices do not work the conference button. The configuration of the meet-me does not work when you connect to the number of meet-me's so busy. Someo...
This is a new install with CUCM 8.5.1. External calls are experiencing a slight delay in the audio which causes a lot of people speaking on top of each other, specifically in conference calls. This is not limited to conference calls, and those conf ...
Hi,This is sachin and I am facing one issue which is mention below:This issue is occuring in 3 production site. we are using call manager version 7.X.When one site of user dialing a number from Missed call directories on Phone, the call is not routin...
How do verify the product ID for Unified Communication Manager and Cisco Unity Connection?
Hi,I have Allworx 6x VoIP server and configured Cisco 7942 IP phones. while using conference bridge Cisco IP phones are not working but Allworx IP phones are working. can any one help me to use Cisco IP phones for conference bridge ?Thanks,saichamana
Hello,I have got the below request from a customer:When an external caller calls an extension and goes to voicemail CUC takes a message and sends an email notification to the user (SIB enabled).The sender name/address is - Cisco Unity Connection Mess...
Hi,I was wondering if the VG202 is supported on the call manager 4.2(3)!I found in the datasheet of the VG202 the following:"The Cisco VG200 supports centralized configuration via Cisco CallManager 3.1 software. This setup allows the Cisco CallManage...
I am getting and "Auth Fail" message on a 7965 that is trying to upload the new firmware version 8.5.3 for sccp to prepare for the DTS bug fix when we go to 6.1.4. How can I fix this?
Hi,Is there a way to change the incoming rtp payload type 99 to 101 in the cisco voice gateway (IAD)Regards.
