Hello, We are currently using a Be6000 system and when we schedule a call forwarding on our phones (model 7945) to external numbers, it works perfectly when the original call comes from an internal position, but when it is an external call then this ...
Hello I have a Cisco 881 VGW with 4 fxs ports and 1 fxo port.I am trying to configure a fxs port so i can plug a ringer into it.I have tried to configure the port as a loop start and also a pots porton the loop config i get registartion rejected and ...
Is there a way to disable the auto dial feature from the missed calls directory? Let me explain, When a caller dials a number and the call was missed, the information will be stored within the Missed calls directory. If the end user wants to call t...
Hello. I was wondering if it was possible to have a PLAR phone automatically dial one phone number during normal business hours (receptionist) but then dial a different number after 5pm. We've got a phone outside the front door of our building that, ...
As our 7936 conf phone ac adapters burn out, we'll be replacing the entire phone with POE 7937's.Today I got my first 7937 which I'd like to configure. However, when I connect it to the LAN, I don't get any power. Does the switch port have to be conf...
Hi again, cisco gurus!Have been looking for SNMP OID that allows to monitor the number of DSP-channels active on Cisco router for some days.Has someone investigated this task? completely perplexed thanks,Boris Borodin
Call forwarding to external numbers are failing from calls orginating from the PSTN. Internal calls forward correctly to the external numbers. This happens with phones only. Call forwarding for internal and external callers for CTI route points wo...
Has anyone implemented an ICT h323 between Cisco CUCM 8 and Nortel using a Nortel Gateeker? Is it possible registering CUCM in a Gatekeeper Nortel?Thanks.Matteo
Hello,I have a customer that lost connectivity to their corp directory recently and gets a message "host not found" when trying to access the corp directory from their phones. Most of the phones are 7940/60 and 7941/61. Directories URL under Ente...
After we make a factory reset on IP phone 7941 it stopped to register on our Call Manager 7.1.3.If I downgrade de firmware version, the Phone restarted every time at the boot (not registered) and with the new Firmware the Phone hangs in the cisco scr...
Sombody please correct me if I'm wrong.When i define a Time Schedual and Time period and apply it to Partition (... this is the correct me part ... ) I am defining when the Partition is active, other wise (outside of the time period) it is de-activat...
Hi all,If I need to configure E1 R2 but the whole channels in E1 will be used for incoming or outgoing so No need to create two voice ports, I just need to create one voice portany body can help me to know which line I should use to configure this ( ...
Hi All,This is a technical question that I’d appreciate some help with. It is quite common on trading floors to have televisions playing in the background. Rather than have sound blaring out, the audio is normally made in to a stream to be replayed t...
Hi,For maximum redundancy, can I deploy multiple SRST routers using HSRP/VRRP/GLBP? Each of the SRST router will have E1 lines. Tks!
I'm looking atmy gateway and can see from using the show voice port stat command that one channel on the PRI (MGCP) is in use. Is there a way to tell who (which DN) is using it? I want to shut down the gateway to change a PVDMII but don't just wan...
HelloI have Cisco IP Communicator installed recentrly and when I press "Directories" button "Corporate Directory" is not showing. I also have 7911, 7940 and 7960 with same problem, but for testing I only use IP Communicator. I suppose it is the same ...
