IP Telephony and Phones

i have ap roblem that the fxo hang suddenly for 30 minutes and that occur nearly ach 2 days

I am trying to route calls over a "hairpinned" T1 on a 2811 router between two MFT-1T1 ports. Works great with PRIs, but I can't get a CAS E&M trunk to work. I know that analog E&M can be tested this way by using a rollover cable with the type that i...

I am connected to a service provider that is using g726. the customer has a spare pvdm2-32 intalled on the mother board. Can i configure this for Transcoding between g711 and g726? if so does any one have a config on how to do this? also when you con...

Hi,BARS(Backup and Restore Server)is not working,in BARS admin page it says:"A Backup or restore process is in progressPlease try again after some time"(this state is for past couple of days)If i RESET, is it BARS will restart the backup imdtly or it...

guys i have setup CCM6 on VMWARE and now at login page i put the th elogin (which i put whil einstalling the CCM 6) but its not taking it keep on saying invalid....which is really pissed me off as i built another server and it the sam eproblem can so...

Hi,I had VWIC2-1MFT-T1/E1 on my router 2811. On the other side is provider router (cisco).I have changed my wic card with VWIC2-2MFT-T1/E1. Now I got error:*Oct 17 07:08:08.529: ISDN Se0/0/0:15 Q931: SETUP pd = 8 callref = 0x0085 Bearer Capa...

Has anyone been able to configure OCS (Beta) where it's using CME (4.1)as it's IP Gateway? I know that mediation server would be needed to convert RTAudio to G.711, however i am looking for any successful installtions or indeed information gathered ...

Can anyone recommend a good free SFTP server to use with the CCM for backups, etc?Thanks,

I just lost some options when I push directories button on 7940. I just can find 3 options, 1.Missed calls, 2 Recived calls, 3 placed call.I would like to know where should I check in my CCME?

I had running Extension Mobility in my CM 4.0 but after installing the IPCC 3.5, co-resident my Extension Mobility stops working. i know this a known issue but i can`t find the answer. Any idea? Thanks

I want to enable VM feature with a reception number running CME 3.3 and CUE 2.1THe reception number (700) is not configured on a seperate phone. I have associated this number as a seperate button for 3 extensions. Any calls to that number lands on an...

Hi all , I m using ATA(SCCP) for FAX on CME 4.1 in 2 sites.i m using a ISDN PRI and am able to send fax , but at one site i get fax every third or 4th time other times i get as No fax detected on the FaX machine.at the second site im not getting any ...

When a external call comes and our operator transfers the call to external number ,after the call ends we still see one of the fxo port hung ,till we reboot the router 2821.please advice.

Hi,,I had installed 2 ccm5.0 servers (publisher and subscriber) and i had registered the publisher and the subscriber and all my ip phones and every thing is fine.the problem when the publisher is went off all the cisco phones goes down, i had alread...