Hello, We are currently using a Be6000 system and when we schedule a call forwarding on our phones (model 7945) to external numbers, it works perfectly when the original call comes from an internal position, but when it is an external call then this ...
Hi community,we experience sort of a strange problem here, but only with our 6945 IP-phones...the telephony part reboots suddenly, several times a day.Users can see it on their displays, even calls get interrupted due to this. When checking more deta...
Hello, I am not well versed in Telephony, so any answers, please keep it simple. I had an event occur recently where phones began to de-register from Call Manager. No configuration changes were being made, nor had there been any recently. We noticed ...
Im trying to configure a FXS port as a hotline.I need to configure FXS port to make a call to an specific phone number as soon the phone is off hook. the endpoint ext is registered on the CUCM.I tried to follow the following steps to achieve this: V...
I have a Polycom Soundstation IP 7000 running version 3.3.1 of it's software that I'm trying to get registered to a Cisco CUCM 7.1.5. We have the users tied in with Active Directory and so I've created an user with the name and password I wanted. Sin...
We are testing out the Cisco IP 8332 phone and based on the manual the LED light should go red when we mute the cal. This isn't the case on my end. When I mute the call, the light just goes away. I can see the image on the screen show that it is mute...
Does the 8800 V-KEM work with the 8865-3PCC? I purchased one and plugged it into the phone and it isn't powering up. I have a power cord on the phone too so it isn't pulling power from PoE.
Where can I find information about the Phone Wipe feature, specially which phones are supported? I cannot find any official notes. I have already searched through Release Notes, Features Guides and Bulk Administratin guides, but got nothing. Thanks e...
instead of using a phone device, i would like to know if I could use a cti route point device
Hello All,I have been trying to access my DRS page but I am finding it very slow to access. When the page loads and I click to check my backup device and schedule list. I have this statust error that "Local Agent is not responding. This may be due to...
How to get all the information and trace the specific IP phone by using RTMT.(duration, called number, and so on...)
Hi Community, Bit of a strange question - I don't think it's possible but just wanting to confirm. Is it at all possible to program a button on an IP Phone handset which effectively blocks the outgoing Caller ID if activated? Thanks,
Hi,I can see a duplicate trunk name in the trunk list , But the partitions are different . Is it possible to create the same trunk name ? (eg: Trunk_Test) The only changes made created another route pattern with different partition . Both route pa...
CISCO SX 20 Model , shall we user 3rd part MIC. IF yes then which MIC (make and Model) will suit, pl recomend.
I have CUCM 6.1(4a)SU2 on production.There are 20 number of VG224, None of the VG224 are getting registerd with CallManager.Day before CUCM version was 6.1(2) some Analog Phones are not getting registered and sometime few VG224 was not getting regist...
Hi experts, one of our clients had requirement to perform contact search using Department/Title, we manage to get it work using the parameter "PredictiveSearchFilter" in Jabber config file. The deployment uses MS Active directory. The Predictive sear...
| User | Count |
|---|---|
| 6 | |
| 2 | |
| 1 | |
| 1 | |
| 1 |
