Hello, We are currently using a Be6000 system and when we schedule a call forwarding on our phones (model 7945) to external numbers, it works perfectly when the original call comes from an internal position, but when it is an external call then this ...
I work for a company that has 200+ remote locations each with a separate voice gateway to handle incoming/outgoing calls. Our larger sites will have a PRI and our smaller sites will have anywhere between 6 and 8 FXO ports to make and receive calls. ...
So we recently had some phones replaced under warranty with these refurbished 7942G models. First 4 phones, we plugged in, they loaded up and we programmed them in CUCM and everything was good. The 5th and 6th phone come up with an error "Registrati...
Hello! Is possible in CM9 to provide dual pickup group for one DN only for example: DN XXX1 belongs to pickup group A DN XXX2 belongs to pickup group B DN XXX3 belongs to pickup group C but also can view notifications from A and B
please suggest is the below mention configuration for IP Phone will be ok ..or do i need to add any other parameter I am facing issue with the conferencing on SCCP phone where it is Model 7945 ! ephone 2 mac-address D4A0.2A89.D388 max-calls-per-bu...
Hi All, I am facing issue with my VG224, clock is not being set on VG224. As soon as i update the clock on VG224 it reverts back after a power cycle need help. Thanks
Dear All, I have my CUCM cluster setup in UK and we have extension mobility for all users. Is there way to find on which desk phone a particular user logged in and I do not want to check with user for this? Regards, Syed
Dear Gents, I am planning to Configure automatic Backup for following application using Symantec backup solution ,CUCM,UCCX,CUC, ExpresswayS ,Jabber Guest Servers. is it possible to do a automatic backup schedule?
Can Cucm V.11 is compatible with ACS??
On inbound calls to phones currently the display shows 916045551212 and I would like the display to show 1604xxxxxxx. On missed calls though I want the 9 inserted so users don't have to edit the dial. I have 1/2 accomplished (the missed calls) but ...
Hi Guys, We cannot see the contact pictures on Cisco jabber. I have change ip address in photo configuration. Please check the attached configuration is fine ?
Is this possible? We're currently using local administrator accounts to access and manager PLM, however, we would like to use active directory accounts to log into PLM. Thanks.
I need some help regarding the topic mentioned. Let me give a brief overview of my issue.My company has an IP Telephony setup in our office complete with a 2811 router and CUCM 8.6.2 with the router installed with 16 FXO ports.Now my boss wants me t...
Hello, Can anyone let me know the models number among Cisco IP Phone 7800 and 8800 thats support BIB(Built In bridge) feature?
Hi all , I have a problem with Cisco 8821 which after starting the phone it connects to WLC ( v.8) and then registers with CUCM (v.10.5) , untill here everything OK but after leaving coverage area and the come back the phone connects to WLC but do no...
One would think FXS ports are simple. I have set up a bunch of FXS port and the first port when called, returns DTMF tones. The configuration on this port is the same as other ports. Is there a way to determine if this port is faulty in some way? ...
