Hello, We are currently using a Be6000 system and when we schedule a call forwarding on our phones (model 7945) to external numbers, it works perfectly when the original call comes from an internal position, but when it is an external call then this ...
Dear IPT Fellows,We recently got a SIP trunk which is connected to our H323 Gateway. H323 Gateway routes all calls to our Call Manager.Inbound and outbound calls are working fine. Inbound DTMF is also working fine but outbound DTMF to SIP trunk is no...
Can I edit an extension in CUCM business edition in unity connection? We are AD sync'ed, I know it is possible I just can't figure it out. I have done it before. I created a wildcard extension (e.g. 229X) and associated that to a CTI route point, I t...
Hi We are building Unity Connection Cluster with 8.5. The Publisher (1st Node) is up and running and has got the High Availaability license installed. Als the Hostname / IP Address of the Secondary node is already added on the Publisher Node of Unity...
Installing a second server (subscriber) to an existing Unity Connection 8.5(1) cluster.The hard drive came pre-loaded with Unity Connection 8.0(3a) so at setup I choose Update during Install, it asked for my ftp into, retrieved the upgrade patch (4GB...
G'dayJust wondering if anyone might have an idea why what would be wrong with my config i have been trying to get the CME to work with a IINet SIP trunk all i got from them is Number range: 08 XXXX X880 - 08 XXXX X899Domain/realm: comapnyname.iib...
HelloI faced strange problem today. I have CUCM 7.0 as a publisher. today I try to install subscriber with excact same version.When installation reaches integration step with publisher, I enter publisher hostname, IP address and security password b...
Hi,I am using Cisco ATA186 with SCCP v 1/1, firmware version 3.10 with CUCME v 7.0. I am getting too much choppy voice and high ping response (above 100ms). What is the issue? ATA's at one location are working fine while at other location same ATAs a...
We are having a building powerdown this weekend and we need to bring down the Call Manager servers. We are running 7.0 with a Publisher and two Subscribers. It is running on the linux platform. Since I am unfamiliar with linux, are there any speci...
I need to not have on-hold music nor repeating beep-beep-beep on a certain DN. How can I do this? Thank you.
I'm trying to import a phone into my call managers and keep getting an error. I have attached a screen shot of the error that is in the CM logs.
With Randy WuWelcome to the Cisco Support Community Ask the Expert conversation. This is an opportunity to learn best practices on how to configure and troubleshoot Cisco Unified Border Element (UBE) for the public switched telephone network (PSTN) S...
Hello, I have recently configured hardware transcoders in our environment to translate between g729 endpoints and our g711 CUCCX system. Works great. Only question is I would like to view its usage on the gateways and can't seem to find the ses...
I am having an issue when a user presses any key on the keypad it does not respond in a timely fashion or the number appears 3 or 4 times. Any ideas?
Hi, I am trying to upgrade my cisco OS 2000.4.3a to version 2003.1.5 and get this error: "this upgrade cannot be run on this server. the minimum os version that supports this upgrade is 2003.1.1". I don't understand thsi error as I am upgrading to ...
Does anyone know if CallManager 4.1 has a baseline demo license, similar to the new versions?EG, on 7.1 we can do a handfull of sets and a couple of VOIP trunks without needing a license.We want to test some interop between a 7.1 and 4.1 system, in t...
