Can anyone advice what the below refer to? I've tried researching online but can't find the specifics to some of the configs.
class OUTPUT-QUEUE-L1 priority level 1 percent 20
Ok so I cannot figure this out at all and would like to understand what's going on. This is on a Cisco 7600 platform.
Router B has an uplink to Router A via TenGig3/1. The path to get to 10.251.197.10/24 goes through this link.
I have been trying to get the ISR1100 (C1111-8P) connected to the internet, but no luck...
My ISP is UPC Cable.
Modem provides a dynamic IP so DHCP is required to obtain the public IP address.
I do get a public IP address.
When I set
I used named EIGRP for IPv4 and IPv6 , for IPv4 it works good, but with IPv6 named EIGRP after configuring the address-family ipv6 unicast autonomous-system 66 then (it automatically makes neighbor relationship with others without the i...